This How to will Cover How to change the DRL BULB AND THE H7 BULBS.
Most will know How to Do this but it will Help those that Don't.

FIRST STEP.......

Left Hand side
Remove the Hose from the Air Filter then Pull the Air Filter Box out
and Place it some were Safe out of the way
your Air Hose may be at the Other end of the Air Filter
but do the Same and Remove the Air Filter Box out of the way
Place a Rag or something over the Hole for the Air Filter
so Nothing can fall Down there.





Now you will have Access to the DRL and the H7 Bulb Holders
Place a Screw Driver in the Slot on the Cover and twist it
then Remove the Cover by hand.





Now squeeze the Black Tabs on the DRL Holder and Gently take it out
just be Real Careful when you Install the New DRL Bulb
that it is Fixed in the Holder Properly
if it Falls in to the Headlight
it is a Nightmare to Get it back Out
i Recommend the PIAA DRL as they fit Perfect.
 


Now you can Remove the Two Caps for the H7 Bulbs
just Twist them off by Hand.





The Bulbs are held in by Two T15 Torx Screws  
just give them a Half Turn
Do not take the Screws Out just Slacken them a bit
Then Twist the H7 Bulb out.



When you put the Bulbs back in Remember too Tighten
up the Two Torx Screws on the h7 Bulbs
too Refit the Air Filter Box put the Rubber Boot it Position first
this will make it alot Easier to get the Air Box back in to Position.



NEXT STEP......

The Right Hand Side.

Pull out the Washer Bottle tube
and Remove the Fuse Box cover.







You can also Remove the 10mm Bolt
from the Headlight fixing arm if you want
again Place a Screw Driver in the slots and Twist
there Really is not alot of Space on this Side
it is Really Tight so take your time.



Getting the DRL back into this Side is Harder
it is much more of a Tight space to work
some Members have Removed the Whole Fuse Box to do this
but it is Possible to do this with out Removing it.



The H7 Covers are the Same it is a very Tight space again
so you will need a Really Small Screw Driver to slacken the Two screws
and Remove the H7 Bulb.  



Hope this has helped Someone out there..

Real easy to do but just take you Time on the Right Hand side
as it is a Tight place to work.

Please note if changing the DRL bulbs for the cheaper Blue DRL bulbs like these

NOTE..........

On some cars you may get and Error about Position lamp,
Check the DRL is Working if it is Check the Rear Lights
as this will Also bring up the Errors on the DRL
if a Taillight has Blown.

Please see the below links for the Suspension systems

Hopefully this will help.

Front

Front Suspension Components
Front Suspension Description and Operation
Fastener Tightening Specifications
Stabiliser Shaft Replacement
Front Lower Control Arm Bush Replacement
Steering Knuckle Replacement
Lower Control Arm Replacement
Stabilizer Shaft Link Replacement
Front Wheel Bearing and Hub Replacement
Strut Assembly Removal and Installation
Strut, Strut Component, or Spring Replacement
Wheel Stud Replacement 2009
Wheel Stud Replacement 2010
Shock Absorber Disposal

Rear

Rear Suspension Components - Watt Linkage
Rear Suspension Description and Operation - Watt Linkage
Fastener Tightening Specifications
Rear Axle Bush Replacement - Watt Linkage
Rear Axle Replacement
Equalizer Beam Link Replacement - Right Side
Equalizer Beam Link Replacement - Left Side
Equalizer Beam Centre Link Replacement
Rear Wheel Bearing and Hub Replacement — Disc Brakes
Shock Absorber Replacement
Rear Axle Bracket Replacement
Wheel Stud Replacement
Rear Spring Replacement
Rear Spring Insulator Replacement
Equalizer Beam Centre Link Heat Shield Replacement
Equalizer Beam Support Replacement
Shock Absorber Disposal

Electronic Suspension Control

Electronic Suspension Control Description and Operation
Fastener Tightening Specifications
Electronic Suspension Control Module Bracket Replacement
Electronic Suspension Rear Position Sensor Replacement
Electronic Suspension Control Module Replacement
Electronic Suspension Front Vertical Accelerometer Replacement - Upper
Electronic Suspension Front Vertical Accelerometer Replacement - Lower
Sport Set-Up Mode Switch Replacement
Tour Set-Up Mode Switch Replacement


Electronic Suspension Control Schematics

Power, Ground and Serial Data
Sensors and Actuators
Tour Mode and Sport Mode Switches (URC)


Electronic Suspension Control DTC's

DTC C0000
DTC C0575, C0580, C0585, or C0590
DTC C0595, C0600, or C0605
DTC C0670 or C0675
DTC C0720
DTC C0870

Would you like to be upgraded to trader status?

We charge £10 per year for allowing you to trade on this forum.
If you have banner made up it can be displayed on the forum then we would also add it.

There are some rules around this.

1.You must be honest with the members here,
2. Members are not here to be ripped off,
3. Any trader found acting in a way as to deceive or rip our member off will be banned,

If you would like apply for trader status then please use the application form from the NAVbar.

Once you have been approved as a  Trader you will be asked to pay the £10 subscription & we will then get a section in the forum under your username, we would be grateful if you could post an introduction thread about you and your company, the services you offer etc, and pics are a must, if you are selling items although you are a trader we still require the picture of the item to include your username and date Hand written and clearly visible.

Kind regards
Rusty site Admin.