Hello all
Bought a 2013 2.0 CDTi back in May. 42k
In July it came up with a SVS message and went into limp mode.
Garage came up with a P2428 error - Exhaust gas temperature sensor 1 - High temp. Low Voltage.
Had the sensor replaced and a forced regen done.
Car has been fine since...
Until Sunday night.
Filled half the tank at Tesco (yes I know, not ideal fuel). 4 miles later SVS light came on and limp mode.
Error didn't clear and car has stayed in limp mode. No EML, no DPF warning, just SVS and limp mode.
Green Flag plugged in Autel AutoLink OBDII this evening and no error code.
Can I keep driving the car until I can get it into the garage?
Any comments greatly appreciated.
Thanks
Bought a 2013 2.0 CDTi back in May. 42k
In July it came up with a SVS message and went into limp mode.
Garage came up with a P2428 error - Exhaust gas temperature sensor 1 - High temp. Low Voltage.
Had the sensor replaced and a forced regen done.
Car has been fine since...
Until Sunday night.
Filled half the tank at Tesco (yes I know, not ideal fuel). 4 miles later SVS light came on and limp mode.
Error didn't clear and car has stayed in limp mode. No EML, no DPF warning, just SVS and limp mode.
Green Flag plugged in Autel AutoLink OBDII this evening and no error code.
Can I keep driving the car until I can get it into the garage?
Any comments greatly appreciated.
Thanks